DDaattaaSShheeeett DDIINN RRaaiill MMoouunntt CMR24 Series • Ratings from 35 A to 65 A @ 660 VAC • 45mm (width) package • SCR output for heavy industrial loads • LED input status indicator • AC or DC control • Zero-crossing (resistive loads) or random-fire (inductive loads) output PRODUCT SELECTION Control Voltage 35 A 45A 55A 65 A 3-32 VDC CMRD2435 CMRD2445 CMRD2455 CMRD2465 90-140 VAC CMRA2435 CMRA2445 CMRA2455 CMRA24065 18-36 VAC CMRA2435E CMRA2445E CMRA2455E CMRA2465E AVAILABLE OPTIONS Operational Current 35: 35 Amps 45: 45 Amps 55: 55 Amps 65: 65 Amps Control Voltage Overvoltage Protection D: 3-32 VDC Blank: No Included Series A: 90-140 VAC P: Included CMR A 24 35 E P -10 Input Range Switching Mode Operating Voltage Blank: Standard Input Blank: Zero Voltage Turn-on 24: 24-280 VAC Required for valid part number E: 18-36 VAC -10: Random Turn-On For options only and not required for valid part number OUTPUT SPECIFICATIONS (1) Description 35 A 45 A 55 A 65 A Operating Voltage (47-63Hz) [Vrms] 24-280 24-280 24-280 24-280 Transient Overvoltage [Vpk] 600 600 600 600 Maximum Off-State Leakage Current @ Rated Voltage [mArms] 10 10 10 10 Minimum Off-State dv/dt @ Maximum Rated Voltage [V/μsec] (2) 500 500 500 500 Maximum Load Current [Arms] 35 45 55 65 Minimum Load Current [Arms] 0.15 0.15 0.25 0.25 Maximum Surge Current (50/60Hz, 1 Cycle) [Apk] 239/250 597/625 954/1000 1145/1200 Maximum On-State Voltage Drop @ Rated Current [Vpk] 1.6 1.6 1.6 1.6 Thermal Resistance Junction to Case (Rjc) [°C/W] 1.02 0.63 0.31 0.28 Maximum I² t for Fusing (50/60Hz, 1/2 cycle) [A² sec] 285/259 1779/1621 4555/4150 4555/4150 Minimum Power Factor (with Maximum Load) 0.5 0.5 0.5 0.5 FDE-07-01 REV. A Do not forget to visit us at: www.crydom.com Copyright © 2017 Crydom Inc. Specifications subject to change without notice.

DataSheet DIN Rail Mount INPUT SPECIFICATIONS (1) Description CMRD24xx CMRA24xx Control Voltage Range (DC or RMS) 3-32 VDC 90-140 Vrms Minimum Turn-On Voltage 3.0 VDC 90 Vrms Maximum Turn-Off Voltage 1.0 VDC 10 Vrms Maximum Reverse Voltage 32 VDC - Maximum Off-State Voltage 1.0 VDC 10 VAC Maximum Input Current 30 mA - Typical Input Current (4) 17 mA @ 5 VDC 15 mA @ 120 Vrms Maximum Turn-On Time [msec] (3) 1/2 Cycle 10 Maximum Turn-Off Time [msec] 1/2 Cycle 40 GENERAL SPECIFICATIONS Description Parameters Dielectric Strength, Input/Output (50/60Hz) 4000 Vrms Minimum Insulation Resistance (@ 500 V DC) 109 Ohms Maximum Capacitance, Input/Output 8 pF Ambient Operating Temperature Range -40ºC to 80ºC Ambient Storage Temperature Range -40ºC to 125ºC Status Indicating Display Green LED Weight (typical) 16.8 oz. (476g) Encapsulation Thermally conductive Epoxy Terminals Cage type Maximum Wire Size: Output: AWG 8 (4.8mm) Input: AWG 12(2.5mm) Recommended Terminal Screw Torque Range: Output:10-15 in lb (1.1-1.7 Nm) Input: 5-6 in lb (0.6-0.7 Nm) GENERAL NOTES 1) All parameters at 25°C unless otherwise specified. 2) Off-State dv/dt test method per EIA/NARM standard RS-443, paragraph 13.11.1 3) Turn-on time for DC control random turn-on versions is 0.02 msec 4) Input circuitry version incorporates active current limiter. Do not forget to visit us at: www.crydom.com Copyright © 2017 Crydom Inc. Specifications subject to change without notice.

DataSheet DIN Rail Mount THERMAL DERATE INFORMATION 35 A 55 A 60 90 s) 50 s) 75 m m Ar 40 Ar 60 nt ( nt ( e 30 e 45 urr urr C 20 C 30 ut ut p p ut 10 ut 15 O O 0 0 10 20 30 40 50 60 70 80 10 20 30 40 50 60 70 80 Ambient Temp. [°C] Ambient Temp. [°C] 45 A 65 A 60 90 s) 50 s) 75 m m Ar 40 Ar 60 nt ( nt ( e 30 e 45 urr urr C 20 C 30 ut ut p p ut 10 ut 15 O O 0 0 10 20 30 40 50 60 70 80 10 20 30 40 50 60 70 80 Ambient Temp. [°C] Ambient Temp. [°C] MECHANICAL SPECIFICATIONS Tolerances: ±0.02 in / 0.5 mm All dimensions are in: inches [millimeters] AGENCY APPROVALS Agency Approvals Designed in accordance with the requirements of IEC 62314 Rev. 090817 E116950 LR 81689 126921 UG (up to 90A models only) ECN 20317 Do not forget to visit us at: www.crydom.com Copyright © 2017 Crydom Inc. Specifications subject to change without notice.

DataSheet DIN Rail Mount DANGER / PELIGRO / DANGER /GEFAHR / PERICOLO / 危险 HAZARD OF RIESGO DE RISQUE DE GEFAHR EINES RISCHIO DI 存在电击、 ELECTRIC DESCARGA DESCHARGE ELEKTRISCHE SCOSSA 爆炸或电弧 SHOCK, ELECTRICA O ELECTRIQUE N SCHLAGES ELETTRICA O 闪烁危险 EXPLOSION, EXPLOSION. OU EXPLOSION ODER EINER DELL’ESPLOSIONE. OR ARC FLASH. • Desconectar • Eteindre EXPLOSION. • Spenga tutta • 在操作此设 • Disconnect all todos los toutes les • Stellen Sie l'alimentazione 备之前请先 power before suministros de sources jeglichen che fornisce 关闭电源。 installing or energia a este d'énergie de Strom ab, der questa working with equipo antes cet appareil dieses Gerät apparecchiatura 若不遵守这些说明， this equipment. de trabajar avant de versorgt, bevor prima di lavorare con este equipo. travailler Sie an dem a questa 可能会导致严重的 • Verify all dessus de cet Gerät Arbeiten apparecchiatura 人身伤害甚至死亡。 connections • Verificar todas appareil durchführen and replace all las conexiones • Verificare tutti • Vor dem covers before y colocar todas • Vérifier tous i collegamenti Drehen auf turning on las tapas antes connections, et e sostituire Energie alle power. de energizer remettre tous tutte le coperture Anschlüsse el equipo. couverts en prima Failure to follow olace avant de überprüfen dell’accensione these El mettre sous und alle instructions will incumplimiento Abdeckungen L'omissione di result in death de estas De non-suivi de ersetzen. queste istruzioni or serious injury. instrucciones ces instructions Unterlassung provocherà la puede provocar provoquera la dieser morte o la muerte o mort ou des Anweisungen lesioni serie lesiones serias. lésions sérieuses können zum sérieuses. Tode oder zu schweren Verletzungen führen. WARNING / AVERTISSEMENT / WARNUNG /ADVERTENCIA / AVVERTENZA / 警告 RISK OF MATERIAL DAMAGE AND HOT RISQUE DE DOMMAGE MATERIEL ET DE GEFAHR VON MATERIALSCHÄDEN UND ENCLOSURE SURCHAUFFE DU BOITIER GEHÄUSEERHITZUNG • The product's side panels may be hot, allow • Les panneaux latéraux du produit peuvent être • Die Seitenwände können heiß sein. Lassen Sie the product to cool before touching. chauds. Laisser le produit refroidir avant de le das Produkt abkühlen, bevor Sie es berühren. • Follow proper mounting instructions including toucher. • Beachten Sie die Montageanweisungen, torque values. • Respecter les consignes de montage, et • Führen Sie keine Flüssigkeiten oder • Do not allow liquids or foreign objects to enter notamment les couples de serrage. Fremdkörper in das Produkt ein. this product. • Ne pas laisser pénétrer de liquide ni de corps étrangers à l'intérieur du produit. Le non-respect de cette directive peut entraîner, Die Nichtbeachtung dieser Anweisung kann Failure to follow these instructions can result in des lésions corporelles graves ou des Körperverletzung oder Materialschäden serious injury, or equipment damage. dommages matériels. zur Folge haben. RIESGO DE DAÑOS MATERIALES Y DE 材料损坏和高温外壳的危险性 RISCHIO DI DANNI MATERIALI E D'INVOLUCRO SOBRECALENTAMIENTO DE LA UNIDAD CALDO • 产品的一侧面板可能很热，在其冷却前请 • Los paneles laterales del producto pueden • I pannelli laterali dell'apparecchio possono 不要触碰。 estar calientes. Esperar que el producto se scottare; lasciar quindi raffreddare il prodotto • 遵照正确的安装说明，包括扭矩值。 enfríe antes de tocarlo. • Respetar las instrucciones de montaje, y en prima di toccarlo. • 请勿让液体及其他异物进入本产品。 • Seguire le istruzioni di montaggio corrette. particular los pares de apretado. • Non far entrare liquidi o oggetti estranei in questo • No dejar que penetren líquidos o cuerpos apparecchio. extraños en el producto. La mancata osservanza di questa precauzione può 如不能正确执行这些操作说明， Si no se respetan estas precauciones pueden causare gravi rischi per l'incolumità personale o 极有可能造成严重人体伤害或者设备的损坏。 producirse graves lesiones, daños materiales. danni alle apparecchiature. Rev 073015 Do not forget to visit us at: www.crydom.com Copyright © 2017 Crydom Inc. Specifications subject to change without notice.

DataSheet DIN Rail Mount ANNEX - ENVIRONMENTAL INFORMATION The environmental information disclosed in this annex including the EIP Pollution logo are in compliance with People’s Republic of China Electronic Industry Standard SJ/T11364 – 2006, Marking for Control of Pollution Caused by Electronic Information Products. Part Toxic or hazardous Substance and Elements Name Lead Mercury Cadmium Hexavalent Polybrominated Polybrominated (Pb) (Hg) (Cd) Chromium biphenyls diphenyl ethers (Cr (VI)) (PBB) (PBDE) Semiconductor die Solder 附件 - 环保信息 此附件所标示的包括电子信息产品污染图标的环保信息符合中华人民共和国电子行业标准 SJ/T11364 - 2006, 电子信息产品污染控制标识要求。 部件 有毒有害物质或元素 名称 铅 汞 镉 六价铬 多溴联苯 多溴二苯醚 (Pb) (Hg) (Cd) (Cr (VI)) (PBB) (PBDE) 半导体芯片 焊接点 50 Do not forget to visit us at: www.crydom.com Copyright © 2017 Crydom Inc. Specifications subject to change without notice.

Mouser Electronics Authorized Distributor Click to View Pricing, Inventory, Delivery & Lifecycle Information: S ensata: CMRA2445-10 CMRD2445-10 CMRA2455-10 CMRD2455-10 CMRA2435 CMRA2455 CMRA2465 CMRD2465- 10 CMRA2445 CMRD2465 CMRD2445 CMRD2455 CMRD2435 CMRA2435-10 CMRD2445P