SSMMDD11 Datasheet revision 1.0 www.chipquik.com SMD Removal Kit (Chip Quik® Alloy 2.5ft, flux, alcohol pads) leaded Product Highlights Easily remove SMD parts with Chip Quik® removal alloy Reduce heat and reduce damage to circuit boards and SMD parts during removal Comes with SMD291 flux Specifications Alloy: Chip Quik® Flux Type: No-Clean Flux Classification: REL0 Melting Point: 58°C (136°F) Chip Quik® Instructions 1 Apply Chip Quik flux to all leads of SMD with syringe or flux applicator. Melt Chip Quik low temperature alloy uniformly on all pins of SMD. 2 Maintain alloy in molten state long enough for complete reflow. 3 Lift chip from board with dental pick or vacuum pen. Thoroughly clean site with swab dipped in flux while applying heat. 4 Clean thoroughly with alcohol pad. 1 © 1994-2015 Chip Quik® Inc.

SMD Removal (With solder iron or warm air bath)  Apply flux to all leads.  Melt CHIP QUIK® uniformly on all pins.  Maintain alloy in molten state long enough to release chip.  Lift chip from board with dental pick or vacuum pen. CLEAN UP  While molten, use cotton swab and flux to move excess to an unused section of board.  While applying heat, polish each pad with a swab and flux until thoroughly clean.  At room temperature, clean residue with alcohol pad.  You are now ready to install the new chip. 2.5 ft of Chip Quik® material, removes 1250 to 1500 SMD pins. Conforms to the following Industry Standards: J-STD-006C, Amendments 1 & 2 (Solder Alloys and Fluxed/Non-Fluxed Solders): Yes RoHS 2 Directive 2011/65/EU: No 2 © 1994-2015 Chip Quik® Inc.

Mouser Electronics Authorized Distributor Click to View Pricing, Inventory, Delivery & Lifecycle Information: C hip Quik: SMD16NL SMD32NL SMD8NL SMD1NL SMD16 SMD32 SMD4.5 SMD8 SMD1