USER GUIDE TB-9028 497AJK HEPA Vacuum Installation, Operation and Maintenance Made in the United States of America Specifications Electrical 120VAC, 50/60Hz, 6.0amps Motor 1 Horsepower Dimensions 17.8" L x 7.8" W x 9.3" H (45.2 cm L x 19.7 cm W x 23.5 cm H) Weight 11 lbs. Certification cULus To Operate 1. Release latches and open lid. 2. Unfasten accessory door and remove vacuum hose, electrical cord and hose attachments. 3. Remove filter plug from vacuum inlet (always Figure 1. 497AJK HEPA Vacuum. replace when repacking for transport). 4. Attach selected accessory to hose. Insert other end Grounding Instructions of hose into inlet. This appliance must be grounded. If it should 5. Latch lid securely. malfunction or break down, grounding provides a 6. Insert hooded end of power cord in power cord path of least resistance for electric current to reduce receptacle on vacuum. the risk of electric shock. This appliance is equipped 7. Plug cord into power outlet. with a cord having an equipment-grounding conductor 8. Turn on power switch. and grounding plug. The plug must be used with an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances. This appliance is for use on a nominal 120-volt circuit. (Check inside each vacuum model motor lid for specific information.) Make sure the appliance is connected to an outlet having the same configuration as the plug. No adapter should be used with this appliance. Any service on this vacuum cleaner should be performed by an authorized service representative. Warning: Improper connection of the equipment- grounding conductor can result in a risk of electric shock. Check with a qualified electrician or service person if you are in doubt as to whether the outlet is properly grounded. Do not modify the plug provided with the appliance. If the plug does not fit the outlet, have a Figure 2. How to operate the 497AJK HEPA Vacuum. proper outlet installed by a qualified electrician. SCS - 926 JR Industrial Drive, Sanford, NC 27332 • (919) 718-0000 • Website: StaticControl.com TB-9028 Page 1 of 3 May 2016 © 2016 DESCO INDUSTRIES, INC. Employee Owned

To Replace Filter The SCS 497AJK HEPA Vacuum is designed for use with disposable SCS Filters. The filters must be replaced on a regular basis. Frequency of filter replacement depends on the type and frequency of use of the 497AJK HEPA Vacuum. 1. Release the latches and open the lid. 2. Remove red filter plug or hose. Save the plug for use later (see WEEE Statement). 3. Grasp the filter on each side by using the circular indentations. Pull filter straight up by both ends. Figure 3. 497AJK HEPA Vacuum parts. 4. Insert the red filter plug in the filter. 5. Dispose of the filter in a suitable manner. Safety Information 6. Remove the red plug from the new filter and position filter in the vacuum with the filter hole to your left. Warning: TO REDUCE THE RISK OF FIRE, ELECTRIC Save the red plug for use in disposing of the filter SHOCK OR INJURY, FOLLOW THESE SAFETY (see WEEE Statement). RULES: 7. Verify that the gasket between the filter and the motor fits tightly. 1. Use only as described in this manual. Use only 8. Insert the red filter plug or hose. manufacturer’s recommended attachments. 9. Close and latch the lid. 2. Do not use this machine to vacuum hazardous dust, flammable or combustible liquids, such as gasoline. 3. Do not use without filter in place. To Store Attachments for Transport 4. Do not leave appliance plugged in when not in use. 1. Unplug the power cord from the outlet and vacuum. Unplug from outlet when not in use and before 2. Open the lid and retrieve the filter plug. servicing. 3. Remove the hose from the inlet and insert the filter 5. Do not handle plug or appliance with wet hands. plug. 6. Do not use appliance outdoors or on wet surfaces. 4. Detach the hose nozzle from the base. Electric shock could occur. 5. Place the hose, power cord and attachments into the 7. Do not use with damaged cord or plug. If appliance lid and close the accessory door. is not working as it should, has been dropped 6. Close the lid and securely fasten the latches. or damaged, left outdoors, or dropped in water, discontinue use. Parts List 8. Keep cord away from heated surfaces. 9. Do not put any object into openings. Do not use with Item Description any opening blocked. 1. SV-PC8 8 Foot Power Cord 10. Connect to a properly grounded outlet only. See 2. HEPA VACUUM HOSE-32 5 Foot Hose Grounding Instructions. 3. SV-CN1 Crevice Nozzle 11. Use extra care when cleaning on stairs. 4. SV-SPF1 Type 1 Fine Particle Filter 12. Turn off all controls before unplugging. 13. Do not pull or carry by cord, use cord as a handle, 5. SV-CB1 Crevice Brush close door on cord or pull cord around sharp edges 6. SV-CS1 Carrying Strap and corners. Keep cord away from heated surfaces. 14. Do not allow to be used as a toy. Close attention is necessary when used near children. 15. Keep hair, loose clothing, fingers and all body parts away from openings and moving parts. 16. Do not pick up anything that is burning or smoking, such as cigarettes, matches or hot ashes. 17. Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord. Notice: Do not operate when filter is full. A lack of suction or exhaust is an indication of a full filter. 18. The appliance is not to be used by children or persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge. 19. Do not allow children to use as a toy. Close attention is necessary when used near children. SCS - 926 JR Industrial Drive, Sanford, NC 27332 • (919) 718-0000 • Website: StaticControl.com TB-9028 Page 2 of 3 © 2016 DESCO INDUSTRIES, INC. Employee Owned

20. If accidental damage occurs discontinue use of this product. 21. Frequent inspection is recommended for physical damage or cracking. Clean regularly with a dry cloth. 22. Never operate this product if the unit has a damaged power cord, power supply or plug. Should the power cord, power supply, or plug found to be worn or damaged replace with SCS recommended power cord SV-PC8. 23. Hearing protection is recommended when operating this unit. Electric shock could occur if used outdoors or on wet surfaces. Caution: To avoid risk of fire, filter must be installed properly and replaced regularly. Do not open filter, reuse filter or attempt to replace components within filter. Regulatory Information cULus Statement Meets cULus requirements. WEEE Statement The following information is only for EU-members States: The mark shown to the right is in compliance with Waste Electrical and Electronic Equipment Directive 2002/96/EC (WEEE). The mark indicates the requirement NOT to dispose the equipment as unsorted municipal waste, but use the return and collection systems according to local law. Dispose of filter and vacuum components properly according to applicable local, state and federal laws. Limited Warranty, Warranty Exclusions, Limit of Liability and RMA Request Instructions See the SCS Warranty - http://staticcontrol.descoindustries.com/warranty.aspx SCS - 926 JR Industrial Drive, Sanford, NC 27332 • (919) 718-0000 • Website: StaticControl.com TB-9028 Page 3 of 3 © 2016 DESCO INDUSTRIES, INC. Employee Owned

Mouser Electronics Authorized Distributor Click to View Pricing, Inventory, Delivery & Lifecycle Information: S CS: SV-CS1 SV-CN1 SV-SPF1 SV-CB1